Onkyo 29400021 - Manuel (Page 8)

8
Front & Rear Panels
The actual front panel has various logos printed on it. They are not shown here for clarity.
The page numbers in parentheses show where you can find the main explanation for each item.
ON/STANDBY button (42)
This button is used to set the AV receiver to On or
Standby.
STANDBY indicator (42)
This indicator lights up when the AV receiver is in
Standby mode, and it flashes while a signal is being
received from the remote controller.
ZONE 2 indicator (120)
This indicator lights up when Zone 2 is selected.
ZONE 3 indicator (120)
This indicator lights up when Zone 3 is selected.
Input selector buttons (60)
These buttons are used to select from the following
input sources: DVD/BD, VCR/DVR, CBL/SAT,
GAME, AUX, TV/TAPE, TUNER, CD, PHONO,
PORT, NET.
Remote control sensor/transmitter (14)
The sensor receives control signals from the remote
controller. The transmitter transmits setting data to
the remote controller.
Display
See “Display” on page 10.
DISPLAY button (61)
This button is used to display various information
about the currently selected input source.
MASTER VOLUME control (60) and indicator
This control is used to adjust the volume of the AV
receiver to –
dB, –81.5 dB through +18.0 dB (rel-
ative display).
The volume level can also be displayed as an abso-
lute value. See “Volume Setup” on page 98.
PURE AUDIO button and indicator (74)
Selects the Pure Audio listening mode. The indica-
tor lights up when this mode is selected. Pressing
this button again selects the previous listening
mode.
Front Panel
Front flap Pull here to open
the flap
TX-NR807_En.book Page 8 Tuesday, July 28, 2009 12:00 PM