Using zone 2/3, R (120), S (120) – Onkyo 29400021 Manuel d'utilisation

Page 120: Multi zone —continued

Advertising
background image

120

Multi Zone

—Continued

This section explains how to turn Zone 2/3 on and off,
how to select an input source for Zone 2/3, and how to
adjust the volume for Zone 2/3.

Controlling Zone 2/3 from the AV receiver

Note:
(TX-NR807)
When Zone 2/3 is turned off, the output
from the 12V TRIGGER OUT ZONE 2/3 goes low (0
volts).

Controlling Zone 2/3 with the Remote
Controller

Note:
To control Zone 2/3, you must press the remote control-
ler’s [ZONE] button first.
The ZONE button turns red while Zone 2 is on, and
green while Zone 3 is on.

Using Zone 2/3

1

To turn on Zone 2/3 and select an
input source, press the [ZONE 2]
or [ZONE 3] button followed by
an input selector button within 8
seconds.

Zone 2/3 turns on, the ZONE 2/3 indi-
cator lights up.

Tip (TX-NR807):
The 12V TRIGGER OUT ZONE 2/3
goes high (+12 V).

To select AM or FM press the
[TUNER] input selector and the
[ZONE 2] or [ZONE 3] button repeat-
edly. You can also select SIRIUS
(TX-NR807: North American mod-
els)
.

To select the same source as that of the
main room, press the [ZONE 2] or
[ZONE 3] button twice. “Zone 2 Selec-
tor: Source” or “Zone 3 Selector:
Source” appears on the display.

2

To turn off Zone 2/3, press the
[ZONE 2] or [ZONE 3] button.
The ZONE 2 or ZONE 3 indicator
flashes.
Press the [OFF] button.
The zone is turned off, and the ZONE 2
or ZONE 3 indicator goes off.

ZONE 3

ZONE 2

OFF

ZONE 2 indicator

ZONE 3 indicator

Input selector buttons

1

Press the [ZONE] button
repeatedly, then point the remote
controller at the AV receiver and
press the [ON] button.

Tip (TX-NR807):
The 12V TRIGGER OUT ZONE 2/3
goes high (+12 V).

2

To select an input source for
Zone 2/3, press the [ZONE]
button repeatedly, followed by an
INPUT SELECTOR button.
To select AM or FM press the
[TUNER] INPUT SELECTOR and the
[ZONE] button repeatedly. You can
also select SIRIUS (TX-NR807:
North American models)
.

3

To turn off Zone 2/3, press the
[ZONE] button repeatedly,
followed by the [STANDBY]
button.

INPUT

SELECTOR

ON

ZONE

STANDBY

TX-NR807_En.book Page 120 Tuesday, July 28, 2009 12:00 PM

Advertising
Ce manuel est liée aux produits suivants: