Turning on the av receiver, Turning on and standby – Onkyo 29400021 Manuel d'utilisation

Page 42

Advertising
background image

42

Turning On the AV receiver

European, Australian and Asian models

: To completely shut down the AV receiver, set the [POWER] switch to the

OFF position (

).

ON/STANDBY

ON/STANDBY

POWER

STANDBY

ON

RECEIVER

STANDBY indicator

(North American and
Taiwan models)

(European, Australian and
Asian models)

STANDBY indicator

Turning On and Standby

1

(European, Australian and Asian models)

Set the [POWER] switch to the ON position (

).

The AV receiver enters Standby mode, and the STANDBY indicator comes on.

2

On the AV receiver, press the [ON/STANDBY] button.

On the remote controller, press the [RECEIVER] button, followed by the
[ON] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.
Pressing the remote controller’s [ON] button again will turn on any components
connected via

.

To turn the AV receiver off, press the [ON/STANDBY] button, or press the remote
controller’s [STANDBY] button. The AV receiver will enter Standby mode. To prevent
any loud surprises when you turn on the AV receiver, always turn down the volume
before you turn it off.

or

Remote

controller

AV receiver

Smooth Operation in a Few Easy Steps

To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the
very first time. These settings only need to be made once.

Did you connect your TV to an HDMI OUT or COMPONENT VIDEO MONITOR OUT?

If you did, “Monitor Setup” (TX-NR807) on page 43.

Run MultEQ Room Correction and Speaker Setup—this is essential!

See “Audyssey MultEQ

®

Room Correction and Speaker Setup” on page 54.

Have you connected a component to an HDMI input,

component video input, or

digital audio input?

If you have, see “HDMI Input Setup” on page 48, “Component Video
Setup” on page 49
, or “Digital Audio Input Setup” on page 50
respectively.

Have you connected an Onkyo MD recorder, CD recorder,

or RI Dock?
If you have, see “Changing the Input Display” on page 53.

HDMI

OUT

IN

TV/TAPE

MD recorder, CD recorder,

RI Dock

TX-NR807_En.book Page 42 Tuesday, July 28, 2009 12:00 PM

Advertising
Ce manuel est liée aux produits suivants: