Remote controller, Installing the batteries, Aiming the remote controller – Onkyo 29400021 Manuel d'utilisation

Page 14: Or/transmitter (14)

Advertising
background image

14

Remote Controller

Notes:
• If the remote controller doesn’t work reliably, try

replacing the batteries.

• Don’t mix new and old batteries or different types of

batteries.

• If you intend not to use the remote controller for a long

time, remove the batteries to prevent damage from
leakage or corrosion.

• Expired batteries should be removed as soon as possi-

ble to prevent damage from leakage or corrosion.

To use the remote controller, point it at the AV receiver’s
remote control sensor, as shown below.

Transmission

Received

Notes:
• The remote controller may not work reliably if the AV

receiver is subjected to bright light, such as direct sun-
light or inverter-type fluorescent lights. Keep this in
mind when installing.

• If another remote controller of the same type is used in

the same room, or the AV receiver is installed close to
equipment that uses infrared rays, the remote control-
ler may not work reliably.

• Don’t put anything, such as a book, on the remote con-

troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.

• The remote controller may not work reliably if the AV

receiver is installed in a rack behind colored glass
doors. Keep this in mind when installing.

• The remote controller will not work if there’s an

obstacle between it and the AV receiver’s remote con-
trol sensor.

• When the remote control codes have been registered

and you want to operate another component
(page 125), or when you want to operate an Onkyo
component without

connection, point the remote

controller at the other component to use it.

• When you want to operate an Onkyo component with

connection or an

-compatible compo-

nent connected via HDMI (pages 127, 128), point the
remote controller at the AV receiver’s remote control
sensor.

Installing the Batteries

1

To open the battery compartment, press
the small lever and remove the cover.

2

Insert the two supplied batteries (AA/R6)
in accordance with the polarity diagram
inside the battery compartment.

3

Replace the cover and push it shut.

Aiming the Remote Controller

Remote control sensor

AV receiver

Approx. 16 ft. (5 m)

30° off center
(Left/Right/Up/Down)

15

15

Transmitter

AV receiver

Approx. 16 ft. (5 m)

Incoming sensor

15° off center
(Left/Right/Up/Down)

TX-NR807_En.book Page 14 Tuesday, July 28, 2009 12:00 PM

Advertising
Ce manuel est liée aux produits suivants: