Speaker settings, First time setup —continued – Onkyo 29400021 Manuel d'utilisation

Page 51

Advertising
background image

51

First Time Setup

—Continued

If the impedance of any speaker is 4 ohms or more but
less than 6, set the minimum speaker impedance to 4
ohms.
If you’ve connected your front speakers to the FRONT
L/R and SURR BACK/ZONE 2 L/R terminal posts for
bi-amping, you must change the “Speakers Type(Front)”
setting. For hookup information, see “Bi-amping the
Front Speakers” on page 21.

Notes:
• When bi-amping is used, the AV receiver is able to

drive up to 5.1 speakers in the main room.

• Before you change these settings, turn down the

volume.

Powered Zone 2/3

See “Setting the Powered Zone 2/3” on page 118.

Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.

Speaker Settings

1

Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.

2

Use the Up and Down [ ]/[ ] but-
tons to select “2. Speaker
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.

3

Use the Up and Down [ ]/[ ] but-
tons to select “1. Speaker Set-
tings”, and then press [ENTER].
The “Speaker Settings” menu appears.

If you change these settings, you must run
Audyssey MultEQ

®

Room Correction and Speaker

Setup again (see page 54).

2. Speaker

Setup

1. Speaker

Settings

2. Speaker

Configuration

3. Speaker

Distance

4. Level

Calibration

5. Equalizer

Settings

6. THX Audio Setup

2–1. Speaker

Settings

Speaker Impedance
Speakers Type(Front)
Powered Zone2
Powered Zone3

6ohms

Normal

Not Act
Not Act

4

Use the Up and Down [ ]/[ ] but-
tons to select “Speaker Imped-
ance”, and then use the Left and
Right [

]/[

] buttons to select:

4ohms: Select if the impedance of any

speaker is 4 ohms or more but
less than 6.

6ohms: Select if the impedances of all

speakers are between 6 and
16 ohms.

5

Use the Up and Down [ ]/[ ] but-
tons to select “Speakers
Type(Front)”, and then use the
Left and Right [

]/[

] buttons to

select:

Normal: Select this if you’ve con-

nected your front speakers
normally.

Bi-Amp: Select this if you’ve con-

nected your front speakers
for bi-amped operation.

Note:
Powered Zone2/3 cannot be used if
“Speakers Type(Front)” is set to
“Bi-Amp”.

6

Press the [SETUP] button.
The setup menu closes.

TX-NR807_En.book Page 51 Tuesday, July 28, 2009 12:00 PM

Advertising
Ce manuel est liée aux produits suivants: