RCA 21028 - Manuel (Page 45)

45
NOTE: If the battery is not properly installed in the handset, or if the battery
pack is not properly connected to the jack inside the battery compartment.
“NO BATTERY” shows in the display when the handset is placed in the
charging cradle.
NOTE:
If a battery is disconnected from the phone and then reconnected, the
phone must be placed in the base or charging cradle for 2 minutes to allow it
to reset.
B
ATTERY
S
AFETY
P
RECAUTIONS
• Do not burn, disassemble, mutilate or puncture. Like other batteries of
this type, toxic materials could be released which can cause injury.
• Keep batteries out of the reach of children.
• Remove batteries if storing over 30 days.
B
ELT CLIP AND
O
PTIONAL
H
EADSET
C
ONNECTING THE
B
ELT
C
LIP
1. To attach the belt clip, insert the sides of the belt clip into
the slots on each side of the handset.
2. Snap the ends of the belt clip into place.
C
ONNECTING AN
O
PTIONAL
H
EADSET TO THE
H
ANDSET
Each handset can be used with an optional headset for hands
free operation.
1. Connect the headset to the headset jack
on the side of the handset The handset
receiver and microphone are disabled
when the headset is connected.
2. Adjust the headset to rest comfortably on
top of your head and over your ear. Move
the microphone to approximately two to
three inches from your mouth.
3. Press the TALK/END/CALLBACK button to
answer a call or make calls using the headset.
4. To return to normal operation, unplug the headset from the jack.
Headset jack
Headset Plug
Belt clip
Slot for belt clip