RCA 21028 - Manuel (Page 26)

26
A
REA
C
ODE
1. Make sure your phone is OFF (not in talk mode).
2. Press the MUTE/PROG button to go to the main menu.
3. Press CID/VOL ( or ) button to scroll to HANDSET SETUP.
4. Press MUTE/PROG button to confirm.
5. Press the CID/VOL ( or ) button to scroll to the AREA CODE menu.
6. Press MUTE/PROG button to enter the menu. SET AREA CODE - - -
shows in the display. The default setting is - - -.
7. Use the touch-tone pad to enter your 3 digit area code.
8. Press the MUTE/PROG button to confirm. You will hear a confirmation
tone and the new area code shows in the display.
NOTE: To restore the default setting to - - -, press and release DEL when
“SET AREA CODE” shows in the display.
R
EGISTRATION
This setting may be made with the expandable handsets. Your dual
handsets are pre-registered and ready to use. It is not recommended that
handset be registered again unless absolutely necessary.
1. Make sure your phone is OFF (not in talk mode).
2. Press the MUTE/PROG button to go to the main menu.
3. Press CID/VOL ( or ) button to scroll to HANDSET SETUP.
4. Press MUTE/PROG button to confirm.
5. If necessary, press the CID/VOL ( or ) button to scroll to the
REGISTRATION menu. Then, press MUTE/PROG button to enter the menu.
REGISTRATION ? 1YES 2NO shows in the display. The default is 2NO.
6. Use the touch-tone pad to select 1 for YES or 2 for NO. Or use the CID/
VOL ( or ) button to scroll to 1YES or 2NO.
7. If you select 1YES, press the MUTE/PROG button to confirm your
selection. HOLD BASE PAGE WAIT FOR BEEP shows in the display.