Denon AVR-484 - Manuel (Page 29)

29
ENGLISH
Using the dimmer function
• Use this to change the
brightness of the display.
The display brightness
changes in four steps
(bright, medium, dim and
off) by pressing the main
unit’s DIMMER button repeatedly.
Front panel display
• Descriptions of the unit’s
operations are also
displayed on the front
panel display. In addition,
the display can be
switched to check the
unit’s operating status while playing a source by pressing
the STATUS button.
Simulcast playback
Use this switch to monitor a
video source other than the
audio source.
Press the VIDEO SELECT
button repeatedly until the
desired source appears on
the display.
Cancelling simulcast playback.
• Select “SOURCE” using the video select button.
• Switch the program source to the component
connected to the video input jacks.
[3] Turning the sound off temporarily (muting)
1 Use this to turn off the audio output
temporarily.
Press the MUTING button.
Cancelling MUTING mode.
• Press the MUTING button again.
• Muting will also be cancelled when MASTER VOL is
adjusted up or down.
[4] Combining the currently playing sound with the desired image
1
[5] Checking the currently playing program source, etc.
1
(Main unit) (Remote control unit)
1
1
2
2 1
(Main unit) (Remote control unit) 1
1
2
(Main unit)
BRIGHT MEDIUM
OFF
DIM
(Remote control unit)
[2] Listening over headphones NOTE:
To prevent hearing loss, do not raise the volume level excessively
when using headphones.
2
1 Connect the headphones to the
PHONES jack of the front panel.
1
PHONES
2 Press the SPEAKER A or B button turn
the speaker off.
Caution: No sound is produced from the headphones when
speakers A or B are turned on.