La Crosse Technology WS-9640-IT - Manuel (Page 2)

2
 Display one of the 8 easy-to-read Temperature condition icons featured by Weather
man
 Temperature display in degrees Fahrenheit (°F) or Celsius (°C) selectable
 Indoor and Outdoor temperature display with MIN/MAX recording
 All MIN/MAX recordings can be reset
 Low battery indicator
 Table standing/ Wall mounting
The Outdoor Temperature Transmitter
 Remote transmission of outdoor temperature to Weather
Station by 915 MHz
 Shower proof casing
 Wall mounting case
 Mounting at a sheltered place. Avoid direct rain and
sunshine
SETTING UP:
1.
First, insert the batteries into the Temperature transmitter. (see “Install and replace
batteries in the Temperature transmitter“).
2. Immediately after and within 2 minutes, insert the batteries into Weather station (see
“Install and replace batteries in the Weather station”). Once the batteries are in
place, all segments of the LCD will light up briefly. Following the time as 12:00 and
the "Weather man" icon will be displayed. If these are not displayed after 60
seconds, remove the batteries and wait for at least 10 seconds before reinserting
them.
3. After inserting the batteries into the transmitter, the Weather station will start receiving
data from the transmitter. The outdoor temperature and the signal reception icon
should then be displayed on the Weather station. If this does not happen after 3
minutes, the batteries will need to be removed from both units and reset from step 1.
4. In order to ensure sufficient 915 MHz transmission however, this should under good
conditions be a distance no more than 100 meters between the final position of the
Weather Station and the transmitter (see notes on “Mounting” and “915 MHz
Reception”).
Note:
 The weather station will receive one outdoor transmitter only.
 If the signal reception is not successful on the first frequency (915MHz) for 22 seconds,
the frequency is changed to 920MHz and the learning is tried another 22 seconds. If still
not successful the reception is tried for 22 seconds on 910MHz. This will also be done
for re-synchronization.
 If after 10 minutes, the Atomic auto-set time (WWVB time) has not been received, press
the SET key to manually enter a time initially.
 Daily WWVB reception is attempted at full hour between 12:00 am to 6:00 am. If the
reception is successful, there will no reception attempt until the following day. When this
is successful, the received time will override the manually set time. The date is also
updated with the received time. (Please refer also to notes on “Atomic auto-set time -
WWVB Radio controlled Time” and “Manual Time Setting”).
BATTERY INSTALLATION
INSTALL AND REPLACE BATTERIES IN THE WEATHER STATION
The Weather station uses 2 x AAA, IEC LR3, 1.5V batteries. To install and replace the
batteries, please follow the steps below:
1. Remove the cover at the back of the weather station.
2. Insert batteries observing the correct polarity (see
marking).
3. Replace compartment cover.
INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER
The Temperature Transmitter uses 2 x AA, IEC LR6, 1.5V battery.
To install and replace the batteries, please follow the steps below:
1.
Remove the battery compartment cover of transmitter.
2. Insert the batteries, observing the correct polarity (see
marking).
3. Replace the battery compartment cover onto the unit.
Note:
In the event of changing batteries in any of the units, all units need to be reset by following
the setting up procedures. This is because a random security code is assigned by the
transmitter at start-up and this code must be received and stored by the Weather station in
the first 3 minutes of power being supplied to it