Setting geq, Note, Geq in the memory – Panasonic CQ-VX777EUC Manuel d'utilisation

Page 14: Operation: general

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

OPERATION: GENERAL

(Continued)

Setting GEQ

© Press SELECT to select GEQ mode.
® • Press W^{frequency selection buttons) to select a frequen­

cy.

Any of the seven frequency bands (80 Hz, 160 Hz, 320 Hz, 640
Hz, 1.6 kHz, 4 kHz, 10 kHz) can be selected. The flashing cur­
sor moves to the left or right each time the corresponding button
is pressed.
The flashing cursor move leftward (bass) when is pressed.

The flashing cursor move rightward (treble) when is

pressed.
Move the flashing cursor to the frequency position you wish to

adjust.

• Press

to adjust the level.

0 dB when the cursor is at the center. Any of the 13 levels can
be selected from +12 dB (cursor at the highest position) to -12
dB (cursor at the lowest position).

Press ■ to raise the level.

Press to lower the level.

Note:

Make the above adjustment while the mode is displayed (for about 5 seconds). If no button is pressed

while it is displayed, it automatically returns to normal mode. In such a case, press SELECT again to

select GEQ.

GEQ in the Memory

© Press SELECT to select GEQ mode.
® Select a desired equalizer characteristic.
@ Press the preset button (1 to 6) you wish to save in the memory

for more than 2 seconds. The preset number flashes, indicating

that it has been saved in the memory.

Note:

If a preset button once saved in the memory is preset again, the

GEQ saved in the memory is erased.

14

CQ-VX777EUC

Advertising