Panasonic DVD-PA65 - Manuel (Page 37)

Recording to MDs and cassette tapes
Analogue recording Digital recording
You can record to an MD or cassette deck
without sound being affected by copy
guards if you use analogue connection. You can record the digital signal directly
onto an MD. All signals will be converted to
48 kHz linear PCM.
Ensure the following conditions are met.
•There is no copy guard recorded on the
disc.
•The recording equipment can handle a
sampling frequency of 48 kHz/16 bit.
■ To make an analogue recording
1. Connect the recording equipment with a
stereo connection cable pages 34
and 36).
•When connecting directly, use the
same method used for connecting a
2-channel amplifier or mini-system
page 36).
2. Set “7 Speaker Setting" to “2-channel”
(• page 38).
• If this is set to “Multi-channel”, only the
audio for the front 2 speakers will be
recorded.
■ To make a digital recording
1. Connect the recording equipment with
an optical fiber cable pages 35 and
36).
•When connecting directly, use the
same method used for connecting a
2-channel digital amplifier or mini­
system (“* * page 36).
Change the digital audio output settings
page 40).
Change the settings as follows.
PCM Down Conversion: Yes
Dolby Digital/DTS Digital Surround:
PCM
2
.
Using headphones
•Turn down the volume before connection, and then adjust the level.
• Headphones with a 3.5 mm (Vs") stereo plug can be connected.
This unit
/-------------------------------------------------- Ti —
Mlkiziri'l ------------------------------------
1..... .. . Y
''VOL 2 TT4TÌÌH.1
1
_____
0
Headphones
[ ^ VOL] (volume) dial
R0T5603