Panasonic PANASYNC S50 - Manuel (Page 15)

To adjust the monitor image press the "Select" button to chose the desired display control func-
tbn and press the "+" orbuttons to make your adjustment.
The monitor will save the adjustment values after tunction is off. The monitor will then store
the saved values in one o1 the eight User Memories (See Page 12).
Front panel controls
OPERATIONS
(D POWER Switch
©
Push once to turn the Power On and once again to turn the
power Off.
(2) Power/DPMS
Indicator
HI]
The Power LED lights green when the power in On.
The Power LED will turn Amber when the Display Power
ManagerT№nt System is active.
The Power Switch is dark when the monitor is Off.
Degauss button
A
Push this button is to demagnetize the CRT if the display
color is abnormal.
@ & CD
buttons
+ &-
Pressing " + " button for incressing or button tor
decreasing the selected control furKition level.
(D Select button
SELECT
Used to select the desired display control function to be
adjusted. A LED is below each of the respective control
function icons arxJ lights to indicate the currently selected
item.
® H-width LED lights when selected to indicate that you may adjust
the image width with the '+" orbuttons.
Cg) H-posrtion
O
LED lights when selected to indicate that you may move
picture image toward left or right with the'+" orbuttons.
(9) V-size CD LED lights when selected to indicate that you may adjust
image height with the "+" orbuttons.
@ V-position
Q
LED lights when selected to indicate that you may adjust
the image up or down.
@ V-pincushion
O
LED lights when selected to indicate that you may adjust
the bowing in or bowing out of the image sides.
® Trapezoid
o
When selected, both the H-width® and H-position ® LEDs
light to indicate that you may correct trapezoid distortion.
® Contrast knob
3-
Sets the image contrast level.'
@ Brightness konb
it—
Sets the image brightness level.
Memory Recall
function
pRecal^i
— +
You can recall the factory Preset or Reservation nnode by
pressing both the "-" & "+' buttons at once for about 2-3
seconds.
Self-Test function
SELECT
The Self-test function can be activated by pressing the "
SELECT" button if there is no video signal or the Power
Management System is active (Power LED is Amber).
— 10 —