Installation ), Installation – Panasonic PANASYNC S50 Manuel d'utilisation
Page 10
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".
( Installation )
■ Connecting Procedures
The sigiial cable connections differ depending what computer you are using. When connecting
to an IBM PC or PC compatible, and when connecting to an Apple computer, connect as shown
below. When connecting to any other system, please refer to that system’s operating manual.
1. Please read these PanaSync S50 Operating Instructions thoroughly before installing the
S50.
2. Before connecting to a computer, always turn the computer power OFF.
3. If the computer is to be connected is an IBM compatible computer, connect the other end
of the video cable attached to the S50 monitor to the computer video output connector.
4. If you are using a Macintosh, please use a UNIMAC'82D Universal Mac Adapter that your
dealer can supply. (It your dealer has not supplied you a UNIMAC-82D then call 1-800'
PANASYS to obtain one.) Connect the UNIMAC-82D Adapter to the Macintosh video out
put connector foilowing the instructions supplied with the UNIMAC-82D. Then attach the
other end of the accessory video cable permanently attached to the S50 monitor to the
other side of the UNIMAC-82D attached to the Macintosh.
5. Connect the supplied S50 AC Power Cord to the S50 CEE 22 connector on the back of
the S50 and plug the other end directly into a grounded electrical outlet.
6. Turn the S50 monitor power switch ON by pressing it once. The monitor’s power indicator
will light Green or Amber.
7. Turn the computer power switch ON.
8. After booting (the PC/Mac power-up sequence and initialization) the Power LED on the
monitor should be Green. It not, check the connectors and the trouble-shooting section of
these Operating Instructions.
9. Referring to these Operating Instructions, set your desired settings.
10. When you done using the monitor, turn OFF the monitor by pressing the monitor’s Power
Switch by pressing it once. The Power LED will darken.
Caution:
The cable connectors must be securely fastened with the screws provided to prevent
accidental disconnection.
— 5 —