Troubleshooting, The on/standby indicator keeps flashing, Temperature" is displayed – Sony CPJ-A300 Manuel d'utilisation

Page 24: Fan" is displayed, The projector does not turn on, No picture is projected, No picture is projected because the power button, Is pressed while the lamp indicator is flashing

Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

Advertising
background image

Troubleshooting

If you run into any problems using the projector,
use the following table to troubleshoot the problem.

If the problem persists, consult your nearest Sony
dealer.

The ON/STANDBY indicator keeps flashing.

• Turn off the power and disconnect the AC power

cord. Wait for more than three seconds. Then
reconnect the AC power cord and turn on the power
again.

• Replace the bulb with a new one (p. 21).

"TEMPERATURE" is displayed.

• Change or clean the filter sponge (p. 20).
• Clean the filter holes so that they are not blocked.
• If the above remedy does not work, consult your

dealer.

"FAN" is displayed.

• Consult your dealer.

The projector does not turn on.

• Check the connection (p. 7 -10).
• Close the bulb cover properly.

No picture is projected.

• Check the connection (p. 7 -10).
• Check the connected source equipment.
• Remove the lens cap.
• Connect the AC power adapter to the IR transmitter

and a wall outlet (p. 7).

• Press the POWER switch to turn on the IR

transmitter (p. 13).

• Prevent the IR receiver from direct sunlight.
• Adjust the position and angle of the IR transmitter

and the mirror for the IR receiver (p. 14).

• Move the IR transmitter closer to the IR receiver.

No picture is projected because the POWER button
is pressed while the LAMP indicator is flashing.

• Turn off the power and disconnect the AC power

cord. Wait for more than three seconds. Then
reconnect the AC power cord and turn on the power
again.

continued

Troubleshooting

25-Eh

Advertising