Sony CPJ-A300 - Manuel (Page 12)

Notes
• If the angle of the IR
transmitter or the IR
receiver is adjusted
past the movable
range, it may cause a
malfunction.
• Do not cover the light
emitter of the IR
transmitter or the IR
receiver with your
hand, etc.
• The infrared rays will
not penetrate walls or
opaque glass.
Therefore, the IR
receiver must be used
within the "in sight"
area of the IR
transmitter.
• The brightness of the
light emitter of the IR
transmitter is not
necessarily stable.
This is not a
malfunction and does
not affect the infrared
coverage distance.
• If the IR transmitter is
positioned too close
to the IR receiver,
noise may appear.
You may eliminate
the noise by adjusting
the mirror.
• Noise appears if the
IR transmitter is out
of the range shown in
the right diagram, or
if the mirror for the
IR receiver comes off.
• Place the IR
transmitter where it
is stable.
Using the AV Cordless IR system -
LASER LINK
Position the IR transmitter and the IR receiver of the
projector so that they operate effectively.
1 Press POWER of the IR transmitter (m ON).
2
Press LASER LINK to turn on the LASER LINK
indicator.
The LASER LINK indicator lights up in red and
"LASER LINK" appiears at the top left comer of the
screen.
LASER LINK
indicator
LASER LINK
The display will go off after 5 seconds.
continued
Projecting 13-El