Sony XM-754HX - Manuel (Page 3)

Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
75 watts per channel minimum continuous average power into 4 ohms,
both channels driven from 20 Hz to 20 kHz with no more than 0.04%
total harmonic distortion per Car Audio Ad Hoc Committee standards,
other Specifications
Circuit system OTL (output transformerless) circuit
Pulse power supply
Inputs RCA pin jacks
High level input connector
Outputs Speaker terminals
Speaker impedance 1* -- 8 il (stereo)
2* - 8 Q (when used as a bridging
amplifier)
Maximum outputs (HI-CURRENT/HI-VOLTAGE)
Four speakers:
90/170 W X 4 (at 4 Q)
Three speakers:
9 0 W x 2 + 2 5 0 W x l / 1 7 0 W x 2 +
400 W X
1 (at 4 il)
Two speakers:
250/400 W
X 2 (at 4 Q)
Rated outputs (HI-CURRENT/HI-VOLTAGE)
(supply voltage at 14.4 V)
Four speakers:
35/75 W
X 4 (20 Hz - 20 kHz, 0.04 %
THD,at4il)
50/100 W
X 4 (20 Hz - 20 kHz, 0.1 %
THD,at20)
Two speakers:
100/200 W X 2 (20 Hz - 20 kHz, 0.1 %
THD, at 4 ii)
Frequency response 5 Hz - 50 kHz ( j^dB)
Harmonic distortion
Input level adjustment
High-pass filter
Low-pass filter
Low boost
Power requirements
Power supply voltage
Current drain
Dimensions
Mass
Supplied accessories
Optional accessories
0.005 % or less (at IkHz, 4 D)
range
0.2 - 4.0 V (RCA pin jacks)
0.4 - 8.0 V (High level input)
50 - 200 Hz, -12dB/oct
50 - 200Hz,-12dB/oct
O - l O d B (40 Hz)
12 V DC car battery
(negative ground)
10.5 -16 V
at rated output: 40 A
(4Q HI-VOLTAGE mode)
Remote input: 1.5 mA
Approx. 258
X 50 X 320 mm
( w / h / d ) (10 * / ♦ X 2 X 1 2 * / b in.) not
ind. projecting parts and controls
Approx. 3.5 kg (7 Ib. 11 oz.) not incl.
accessories
Mounting screws (4),
Terminal cap (1)
Connecting cord for power amplifier
RC-46
Design and specifications are subject to change wid\out
notice.
* HI-CURRENT only