Tweco 150XL CE PAK Master - Manuel (Page 19)

Manual 0-2826 3-1 INSTALLATION
SECTION 3:
INSTALLATION
3.01 Introduction
NOTE
Depending on how the system was ordered, some
Power Supply options may already be installed.
If option(s) have been factory installed some of the
instructions may not apply. It is recommended
that all sub-sections be read for general informa-
tion.
This section describes installation of the Power Supply
and connecting the Torch.
These instructions apply to the Power Supply only; in-
stallation procedures for the Torch, Options, and Acces-
sories are given in Manuals specifically provided for those
components.
The complete installation consists of:
1. Site selection
2. Unpacking
3. Connections to Power Supply
a. Input power
b. Internal power selection
c. Work cable
b. Gas connections
d. Torch Installation
e. Connecting auxiliary devices
4. Grounding
5. Operator training
3.02 Site Selection
Select a clean, dry location with good ventilation and ad-
equate working space around all components.
NOTE
Review Important Safety Precautions in Section 1
to be sure that the selected location meets all safety
requirements.
The power supply is fan cooled by air flow through the front
panel to the rear panel. Air flow must not be obstructed. Pro-
vide at least 2 feet (0.6 m) in the rear and at least 6 inches (0.2 m)
on each side for clearance. Provide sufficient clearance in front
of the unit to allow access to the front panel controls (minimum
6 inches or 0.2 m).
CAUTION
Operation without proper air flow will inhibit
proper cooling and reduce duty cycle.
3.03 Unpacking
NOTE
Equipment that was ordered as a system is pack-
aged in one shipping carton. All options and the
torch are factory installed.
Each component of the system is packaged and protected
with a carton and packing material to prevent damage
during shipping.
1. Unpack each item and remove all packing material.
2. Locate the packing list(s) and use the list to identify
and account for each item.
3. Inspect each item for possible shipping damage. If
damage is evident, contact your distributor and/or
shipping company before proceeding with system
installation.
3.04 Transporting Options
WARNINGS
Do not touch live electrical parts.
Disconnect input power conductors from de-ener-
gized supply line before moving unit.
• Use the lifting eye located in the Top Panel to lift
the Power Supply with cable and hook (see
NOTE).
NOTE
Do NOT lift the Power Supply by the handle.
• Do NOT pull power supply by torch leads. Use the
handle and wheels to move the power supply.
WARNING
FALLING EQUIPMENT can cause serious per-
sonal injury and equipment damage.