Brother PQ1300 - Manuel (Page 19)

CONTENTS
Accessories
Names of
Parts
Before You
Begin
Changing
Needles and
Light Bulb
Threading
Stitch
Samples and Needle Chart
Changing
Presser Feet
Basic Sewing
Caring for
Your
Machine
Trouble Shooting
15
5 Sew zipper onto fabric along
mark.
6 Line up folded seam to stitches.
7 Change position of zipper foot.
8 Turn hand wheel to lower needle
and make sure the needle and
position of the foot are lined up
properly.
9 Baste zipper onto fabric and sew
along edge with fabric right side
up.
✽ Reinforce base of opening by
sewing over it twice.
✽ If the zipper slide gets in the way,
lower the needle all the way
through the fabric, lift the foot,and
move the slider out of the way.
Note
Make sure power is off before changing feet.
Zipper Foot
1 Attach zipper foot.
2 Turn hand wheel to lower needle
and adjust position of foot to
needle.
3 Line up zipper to the section of
fabric it will be attached to, and
mark the base of the opening on
the fabric. It should be set
approximately .5 centimeters
below zip stop.
4 Fold hem about .2 cm from mark,
and make a mark along the edge.
Basic Sewing (3)
A
B
0.2cm
0.5cm
Stop
Slide
Base of
Opening