Aquascape Waterfall Light (99383) - Manuel (Page 4)

4
5) replacing the Bulb
1) Make sure the transformer is uplugged before
changing the bulb. The light housing must be
above water to properly service the light bulb.
2) Unscrew the aluminum head from the cord.
3) Pull the bulb out of the socket.
4) Insert the new bulb by inserting the two plugs
into the connector. Note: Do not touch the new
bulb with bare hands.
5) Attach the cap back onto the light cord.
6) Test to make sure the light works.
7) Position light back into the pond.
2
4
Bulb
Plug
O-Ring
Head
6) Troubleshooting
• Double check to see if all of the connections are still intact and that there are no exposed wires.
Ensure that the wires are fully sealed with the wirenuts.
• The two copper wire stubs at the end of the cut light cable must not be touching each other.
Crossing wires will cause the transformer to burn-out! Re-cut if the wires are crossing or the
original cut was not precise.
• Bulb life can be greatly increased by setting timer on the transformer so the light(s)
only operate during the desired viewing times. (ex. On at dusk, and off at 1:00 a.m.)
99383 Waterfall Light Instructio4 4 8/29/06 10:03:01 AM