Waterfall light – Aquascape Waterfall Light (99383) Manuel d'utilisation

Page 3

Advertising
background image

Waterfall Light



Placement of Lights:
Find a desirable location for the light(s). Please see diagram below for proper placement.

We suggest positioning the lights so they are facing upward into the waterfall. The light is

designed to be incorporated into the floor of the stream by “tucking” it in-between a set of boul-

ders. The boulders can be adjusted around the light in order to “lock” the light into position.
Placement of Light Cord:
The light cord should be run along the liner to the outside perimeter of the pond. Place the

light cord behind any boulders on the vertical walls. Please see Diagram. Gravel can now be

spread across the stream, covering all of the liner as well as the light cord(s).

) Installing The Transformer

It’s best to connect the lights to the low voltage cable when the pond is near completion,

typically following the final steps, such as, trimming and preparing the edges of the pond.

The transformer comes with a short 24 inch cord and will need to be mounted very close to

the electrical supply. This will allow the transformer and pump to be plugged into the

same location.
• Strip approximately 1/2 inch – 3/4 inch insulation from the 16 gauge flat LVL cable.
• Now attach the 16 gauge flat LVL cable, using the screws included in the lid of the trans-

former to the pressure plate on the bottom.

• Lay the flat LVL cable along the edge of the pond. Please see diagram below for

proper positioning.

BIO-

FALLS

®

FILTER

Direction of

Stream

Waterfall

Light

IMPORTANT: Before installing lights under water make sure the light head is firmly screwed

on. Failure to do so may cause the housing to leak!

4) Using Wire Nuts

• Split the cable and strip wire insulation,

exposing at least 1/2” of wire on each side.

Repeat for the LVL cable.

• Fill the wirenut with sillicone.
• Hold one set of bare wires together and twist

on the wire nut. Repeat for other wire ends.

• Wrap connection with electrical tape.

99383 Waterfall Light Instructio3 3

8/29/06 10:03:00 AM

Advertising