Philips MX5100VR-37 - Manuel (Page 8)

8 Hookups (cont’d)
System to TV only
Simplest connection using only the supplied black RF coaxial cable
This connection will let you use the features of both the VCR and the DVD Player.
VIDEO
TV ANTENNA
AUDIO R L
PROGRESSIVE
OUT IN
ANTENNA 75
Ω
ANTENNA 75
Ω
Y
Pb/Cb
Pr/Cr
FM
(75 Ω )
DIGITAL
AUDIO OUT
COAXIAL
S-VIDEO
OUT
VCR
IN
DVD/
VCR
OUT
COMPONENT
VIDEO OUT AM
FL
FR
C
SL
SR
W
SPEAKER (4 Ω )
P I
Antenna
or Cable TV
Signal
Back of TV
(example only)
ANTENNA IN
RF IN
RF coaxial cable
1
Disconnect the antenna or Cable TV signal from your TV and connect it to the TV
ANTENNA IN jack on the System.
2
Connect the supplied black RF coaxial cable to the System’s TV ANTENNA OUT jack
and to the Antenna In jack on the TV.
The ANTENNA IN jack on the TV may be labelled TV IN,
RF IN, 75Ω (ohm), or ANT. IN. See your TV owner’s manual for assistance.
3
Set the P/I PROGRESSIVE switch on the rear of the System to I (Interlace).
4
You are ready to connect the AM and FM antennas and the Speakers. See pages 16-17
to connect these items.
5
When all connections are complete, plug in the power cords of the TV and the System.
6
Set your TV to channel 3 or 4. The System’s output channel is 3 when you purchase it. So, set
your TV to channel 3 when the System is new.
If you cannot use channel 3 at your TV, you can change the System’s output channel to channel 4.To
do so, press the VCR button to put the System in VCR mode.The red VCR light will be on the front
of the System. Insert a videotape and press PLAY B to start playback. (You cannot change the
System’s output channel when you adjust the tracking manually. In this case, press STOP C to stop
the playback once.Then, press PLAY B to start playback again.)
During playback, press and hold the (VCR) PLAY B button on the front of the System
for three to five seconds.
Each time you do this, the System’s output channel switches between 3
and 4. Change your TV to channel 3 or 4 accordingly.
There is not a channel 3/4 switch on the System (as customary with most VCRs).
7
If you have not turned on the System already, go to page 19 to complete the VCR’s
First-Time Setup.
This process sets up the TV channels and the language for the VCR menu.
MX5100VR.qxd 6/04/2004 3:37 PM Page 8