Philips MX5100VR-37 - Manuel (Page 20)

20 Video Cassette Playback
Read and follow the steps below to play a tape.
1
Turn on the TV. Set it to channel 3 or 4 or its
AUDIO/VIDEO IN channel.
This depends on how you
connected the System to a TV. Details are on pages 8-11.
2
With the System’s power off, insert a tape in the
cassette compartment.
The STANDBY-ON and VCR lights
will appear on the front of the System. If the tape’s record tab
has been removed, playback will start automatically.
Or, if the System’s power is already on, press VCR to put the
System in VCR mode.The red VCR light will appear on the
front of the System.
3
If play does not start automatically, press VCR, then
press PLAY
B .
4
Press STOP C to stop playback.
5
Press REW h to rewind the tape.
6
After the tape stops, press STOP/EJECT C A on the
front of the System to remove the tape.
• Other tape playback features are
on pages 42-46.
• If AUTO REPEAT is ON, playback
will begin when you insert a tape,
even when the record tab is intact.
Details are on page 42.
• You must connect the System to a
TV using the RF coaxial cable or
the audio/video cables in order to
use the VCR features.These
hookups are explained on pages
eight and 11.
• You cannot use the VCR when the
System is in Tuner mode. If you fast
forward, rewind, or eject a videotape,
you may hear noise through the
speakers or some displays may be
incorrect.
• You cannot use the Tuner when the
System is in VCR mode. Make sure
you stop tape play before putting
the System in Tuner mode.
Helpful Hints
STANDBY-ON
TIMER SET
VCR/TV
SEARCH MODE
REPEAT
TUNER
3
4 5 6
7 8 9
SLOW
0 +10
2 1
VCR DVD
CLEAR
DISPLAY
SETUP/
PROG
TITLE RETURN MODE/SPEED
C-RESET
AUDIO/
BAND ANGLE SUBTITLE
ZOOM
DISC
MENU OK
PAUSE
REW FF
PLAY STOP
SKIP/
CH
SKIP/
CH
REPEAT
SOUND SURROUND
+ –
VOLUME
REC
A-B
1
Turn on the TV.
2
Insert a tape in the System.
3
6
Press STOP/EJECT C A on
the System.
4
5
MX5100VR.qxd 6/04/2004 3:37 PM Page 20