Ipod messages, Usb messages, Resetting the main unit – Pioneer HTP-FS500 Manuel d'utilisation

Page 81: Additional information 10

Advertising
background image

Additional information

10

81

En

English

Deutsch

Italiano

Español

Français

Nederlands

iPod messages

USB messages

Resetting the main unit

Use this procedure to reset all the system’s
settings to the factory default. Use the front
panel controls to do this.

1

Switch the system into standby.

2

While holding down the ST/MONO

button, press and hold the

STANDBY/ON

button for about two seconds.

3

When you see RESET? appear in the

display, press TUNE –.
OK?
shows in the display.

4

Press TUNE + to confirm.

OK appears in the display to indicate that the
system has been reset to the factory settings.

Symptom

Cause

Action

iPod/USB Error 1
(I/U ERR1)

There is a problem with the signal path
from the iPod to the system.

Switch off the system and reconnect the
iPod to the system. If this doesn’t seem to
work, try resetting your iPod.

iPod/USB Error 2
(I/U ERR2)

The software version being used with the
iPod needs to be updated.

Update the software being used with the
iPod (please use the latest iPod software
versions later than the iPod updater 2004-
10-20).

An iPod not supported by this system is
connected.

Connect the iPod supported by this
system.

iPod/USB Error 3
(I/U ERR3)

When there is no response from the
iPod.

Update the iPod software to the latest
version. If this doesn’t seem to work, try
resetting your iPod.

No Track

When there are no tracks in the category
selected on the iPod.

Select a different category.

Symptom

Cause

Action

iPod/USB Error 1
(I/U ERR1)

There is a problem with the signal path
from the USB to the system.

Switch off the system and reconnect the
USB to the system.

iPod/USB Error 3
(I/U ERR3)

When there is no response from the
USB.

Switch off the system and reconnect the
USB to the system.

iPod/USB Error 4
(I/U ERR4)

The power requirements of the USB
device are too high for this system.

Switch off the system and reconnect the
USB to the system.

HTP-700_VYXCN_En.book 81 ページ 2009年9月15日 火曜日 午前9時42分

Advertising
Ce manuel est liée aux produits suivants: