Pioneer HTP-FS500 - Manuel (Page 43)

Controls and displays 03
43
En
English
Deutsch
Italiano
Español
Français
Nederlands
Press first to access:
BASS –/+
Use to adjust Bass
1
TRE –/+
Use to adjust Treble
1
Press TV first to access:
DTV/TV
Switches between the DTV and analog TV
input modes for Pioneer flat screen TVs.
14 MUTE
Mutes/unmutes the sound.
15 Number buttons and other component
controls
Use the number buttons to directly select a
radio frequency (page 54) or the tracks on a
CD, DVD, etc. There are other buttons that can
be accessed after the
button is
pressed. (For example MIDNIGHT, etc.)
HDD*, DVD*, VCR*
These buttons switch between the hard
disk, DVD and VCR controls for HDD/DVD/
VCR recorders.
S.RETRIEVER
Press to restore CD quality sound to
compressed audio sources (page 59).
EQ
Press to switch on/off Acoustic Calibration
EQ setting (page 60).
CH SELECT
Press repeatedly to select a channel, then
use
+/– to adjust the level (page 68).
CH SELECT +/–
Use to adjust the channel level.
SB CH
Use to select the surround back channel
mode (page 62).
PHASE
Press to switch on/off Phase Control
(page 60).
MIDNIGHT
Switches to Midnight or Loudness
listening (page 63).
SLEEP
Press to change the amount of time before
the system switches into standby (
30 min
– 60 min – 90 min – Off). You can check
the remaining sleep time at any time by
pressing
SLEEP once.
16 DISPLAY
Switches the display of this unit. The input
name, listening mode or sound volume can be
checked by selecting an input source.
17 SHIFT
Press to access the ‘boxed’ commands (above
the buttons) on the remote. These buttons are
marked with an asterisk (* ) in this section.
Note
1 The tone controls are disabled when the listening mode is set to DIRECT or PURE DIRECT.
HTP-700_VYXCN_En.book 43 ページ ２００９年９月１５日 火曜日 午前９時４２分