Sony CLM-V55 - Manuel (Page 20)

20-GB
Note ˎ ¦
When this unit is connected to the camera by the HDMI cable, the following
may happen depending on the camera.
No image appears on the camera’s LCD screen. ˎ ˋ
The camera switches to playback mode. (Make sure the camera is in shooting ˎ ˋ
mode before taking pictures.)
Tip ˎ ¼
After a certain time in either of the following conditions, the backlight of this ˎ ˎ
unit turns off.
No HDMI signal is output from the camera ˎ ˋ
The HDMI cable is disconnected ˎ ˋ
Carrying out the following turns the backlight on again.
Press the operation dial of this unit. ˎ ˋ
Operate the camera so that an HDMI signal is output. ˎ ˋ
Reconnect the HDMI cable and turn the camera on. ˎ ˋ
To remove from the camera
Disconnect the HDMI cable and remove this unit as below.
Note ˎ ¦
When removing, be careful not to drop this unit or the camera. It is ˎ ˎ
recommended that you attach the camera to a tripod before removing
this unit.
When using an auto lock accessory shoe:
Push the lock lever of the shoe adaptor down to the left to release the lock. ʓ
Keeping the lock lever pressed to the left, slide the shoe adaptor toward you. ʔ