Saving the measurement results – Sony STR-DA4400ES Manuel d'utilisation

Page 48

Advertising
background image

48

GB

To save the measurement results obtained in
“Performing auto calibration” (page 45),
proceed with the following steps.

1

Press

B/b to select “Yes” in

step 8 in “Performing auto
calibration,” then press

.

The selecting screen of the calibration
type appears.

2

Press

V/v repeatedly to select

the auto calibration type, then
press .

The measurement results are saved.

3

Press

b.

The exit screen appears.

4

Press .

Notes

• After reflecting the results of a compensation for a

frequency characteristic, signals with a sampling
frequency of higher than 96 kHz are always played
back at either 44.1 kHz or 48 kHz.

• The frequency response measurement result is not

utilized in the following cases.
– The multi-channel input is selected.
– “2ch Analog Direct” is being used.

• The measurement result is not utilized when Dolby

TrueHD signals with a sampling frequency of
higher than 96 kHz are being received.

Tip

The size of a speaker (LARGE/SMALL) is
determined by the low characteristics. The
measurement results may vary, depending on the
position of the optimizer microphone and speakers,
and the shape of the room. It is recommended that
you follow the measurement results. However, you
can change those settings in the Speaker settings
menu. Save the measurement results first, then try to
change the settings if you want.

Saving the measurement results

Parameter

Explanation

Full Flat

Makes the measurement of
frequency from each
speaker flat.

Engineer

Sets the frequency to one
that matches that of the
Sony listening room
standard.

Front Reference Adjusts the characteristics

of all the speakers to match
the characteristics of the
front speaker.

OFF

Sets the auto calibration EQ
to off.

Advertising