Troubleshooting, Audio – Sony STR-DA4400ES Manuel d'utilisation

Page 136

Advertising
background image

136

GB

Troubleshooting

If you experience any of the following
difficulties while using the receiver, use this
troubleshooting guide to help you remedy the
problem. Should any problem persist, consult
your nearest Sony dealer.

There is no sound, no matter which
component is selected, or only a very
low-level sound is heard.

• Check that the speakers and components

are connected securely.

• Check that all speaker cords are connected

correctly.

• Check that both the receiver and all

components are turned on.

• Check that MASTER VOLUME control is

not set at –

∞ dB. Try to set it at about –40

dB.

• Check that SPEAKERS (OFF/A/B/A+B)

is not set to OFF (page 44).

• Press MUTING on the remote to cancel

the muting function.

• Check that you have selected the correct

component with INPUT SELECTOR.

• Check that headphones are not connected.
• When only a very low-level sound is

heard, check to see if NIGHT MODE is
activated (page 96).

• The protective device on the receiver has

been activated. Turn off the receiver,
eliminate the short-circuit problem, and
turn on the power again.

There is no sound from a specific
component.

• Check that the component is connected

correctly to the audio input jacks for that
component.

• Check that the cord(s) used for the

connection is (are) fully inserted into the
jacks on both the receiver and the
component.

There is no sound from one of the front
speakers.

• Connect a pair of headphones to the

PHONES jack to verify that sound is
output from the headphones. If only one
channel is output from the headphones, the
component may not be connected to the
receiver correctly. Check that all the cords
are fully inserted into the jacks on both the
receiver and the component. If both
channels are output from the headphones,
the front speaker may not be connected to
the receiver correctly. Check the
connection of the front speaker which is
not outputting any sound.

• Make sure you have connected both the L

or R jack to an analog component and not
just to either the L or R jack. Use a
monaural-stereo cable (not supplied).
However, there will be no sound from the
center speaker when a sound field (Pro
Logic, etc.) is selected. When the center
speaker is not connected, sound is output
only from the front left/right speakers.

There is no sound from analog 2
channel sources.

• Check to make sure the selected audio

(digital) input jack is not assigned to other
inputs in “Input Assign” in the Input menu
(page 93).

There is no sound from digital sources
(from COAXIAL or OPTICAL input jack).

• Check that the INPUT MODE is not set to

“Analog.”

• Check that the “2ch Analog Direct” is not

being used.

• Check to make sure the selected audio

(digital) input jack is not assigned to other
inputs in “Input Assign” in the Input menu
(page 93).

Audio

Advertising