Video tuner – Sony STR-DA4400ES Manuel d'utilisation

Page 138

Advertising
background image

138

GB

The MULTI CHANNEL DECODING lamp
does not light up in blue.

• Check that the playback component is

connected on a digital jack and the input is
selected properly on this receiver.

• Check whether the input source of the

software being played back corresponds to
the multi-channel format.

• Check whether the setup on the playback

component is set to multi-channel sound.

• Check to make sure the selected audio

(digital) input jack is not assigned to other
inputs in “Input Assign” in the Input menu
(page 93).

There is no sound from the component
connected to the DIGITAL MEDIA PORT
adapter.

• Adjust the volume of this receiver.
• The DIGITAL MEDIA PORT adapter

and/or component is not connected
correctly. Turn off the receiver, then
reconnect the DIGITAL MEDIA PORT
adapter and/or component.

• Check the DIGITAL MEDIA PORT

adapter and/or component device to make
sure it supports this receiver.

There is no picture or an unclear
picture appears on the TV screen or
monitor.

• Select the appropriate input on the receiver

(page 53).

• Set your TV to the appropriate input mode.
• Move your TV away from the audio

components.

• Assign the component video input

correctly.

• The input signal should be same as input

when you are up-converting an input
signal with this receiver (page 37).

The image of the COMPONENT VIDEO
OUT is corrupted.

• Video input signals other than 480p

component are not received when signals
are output from the VIDEO jack. Input
480i component video signals.

• When component input signals other than

480p are output, use the COMPONENT
VIDEO OUT jack and set “Resolution” to
“DIRECT.”

Images of the source with HDMI
connection is not output to the TV.

• Make sure that cables are correctly and

securely connected to components.

• Depending on the playback component,

component may need to be set up. Refer to
the operating instructions supplied with
the each component.

• Be sure to use a connecting cable for the

HDMI jack corresponding to high speed
(an HDMI version1.3a, category 2 cable)
when you view images or listen to sound
during a Deep Color transmission.

Recording cannot be carried out.

• Check that the components are connected

correctly (page 30).

• Select the source component (page 53).

The GUI does not appear on the TV
screen.

• Press GUI MODE to display “GUI

MODE” on the display.

• Check the TV is connected correctly.

The FM reception is poor.

• Use a 75-ohm coaxial cable (not supplied)

to connect the receiver to an outdoor FM
antenna (aerial) as shown on page 139. If
you connect the receiver to an outdoor
antenna (aerial), ground it against
lightning. To prevent a gas explosion, do
not connect the ground (earth) wire to a
gas pipe.

Video

Tuner

Advertising