Sony XBR-49X850B - Manuel (Page 20)

D:\SONY TV\SY140104_Clover 67 (Rev-1)\4533569121_US\US03STU.fm
XBR-70X850B / 65X850B / 55X850B / 49X850B / KDL-70X830B / 65X830B / 55X830B
4-533-569-12(1)
20 US
Consider the following measures when
securing your TV to a Stand (not supplied).
1
Secure the Stand for the TV.
Make sure the Stand can adequately
support the weight of the TV. Use two
angle braces (not supplied) to secure
the stand. For each angle brace use the
appropriate hardware to:
• Attach one side of the angle brace to
the wall stud.
• Attach the other side to the Stand.
2
Secure the TV to the Stand.
Use the optional hardware listed as
follows (not supplied):
• M4 machine screw (screwed into the
TV’s rear cover)
• A screw or similar (attach it to the
Stand)
• Rope or chain (strong enough to
support the weight of the TV). Make
sure that there is no excess slack in
the rope or chain.
The length of the M4 machine screw
differs depending on the rope or chain
diameter. Please see below illustration.
3
Anchor the TV to the wall by using bolts,
wall anchor and chain (or rope).
~
• Your TV is shipped with screws attached
to the rear of the TV depending on the TV
model. (They are fastened in the screw
holes for wall mounting.) Be sure to
remove the upper two screws prior to
anchoring the TV to a wall.
• Securing the TV to the stand without
securing the TV and the stand to the wall
provides minimum protection against the
TV toppling over. For further protection,
be sure to follow the three measures
recommended.
Recommended Measures
to Secure the TV
Stand
Angle brace
(not supplied)
Screw hole on
the rear cover
M4
machine
screw (not
supplied)
Rope or chain
(not supplied)
Screw
(not supplied)
Screw M4
Rope or chain
TV’s rear cover
8-12 mm
Anchor bolts (M6) (not supplied)
Wall-
mount
holes
Rope or
chain (not
supplied)
Wall-anchor
(not
supplied)