Sony MHC-W55 - Manuel (Page 6)

EN
6
Chapter 1: Setting Up
Setting the Clock
The built-in clock shows the time in the
display even if the power is off.
Use the buttons on the unit to do this
operation.
Note
Once you set the clock, the demo mode,
that activates when the power is turned off,
is cancelled automatically.
1
Press TIMER.
The stereo enters the clock/timer mode.
2
Press CLOCK SET.
The “AM” and hour indication begin
flashing.
3
Set the current hour by turning the JOG
dial until the correct hour appears.
4
Press ENTER/NEXT.
The minutes indication begins flashing.
5
Set the current minute by turning the
JOG dial until the correct minute
appears.
Inserting the
Batteries
Install two R6 (size AA) batteries in the
supplied remote for remote control.
1
Slide the lid to remove it.
2
Insert two R6 (size AA) batteries.
Match the + and – to the diagram in the
battery compartment.
3
Close the lid.
Battery life
You can expect the remote to operate for
about six months (using Sony SUM-3 (NS)
batteries) before the batteries run down.
When the batteries no longer operate the
remote, replace all the batteries with new
ones.
To avoid battery leakage
If you are not going to use the remote for a
long time, remove the batteries to avoid
damage caused by corrosion from battery
leakage.
6
Press ENTER/NEXT.
The clock starts running and the upper
dot flashes. Use the time signal to set the
clock accurately.
The upper dot flashes for the first half of
a minute (0 to 29 seconds), and the
lower dot flashes for the last half of a
minute (30 to 59 seconds).
To check the time while power is on
Press DISPLAY a few times.
The current time is displayed for 8 seconds.
To correct the clock setting
Repeat steps 1 through 6.
flashing
flashing
flashing
SYSTEM
POWER m ON
DISPLAY
2
4,6
1
3,5
flashing
flashing