Aube Technologies TA7210 - Manuel (Page 19)

EConnect™ TA7210
19
Follow the guidelines below when mounting the thermostat:
• Do NOT install the thermostat in an area where it can be exposed to water or rain.
• Avoid locations where there are air drafts (top of staircase, air outlet), dead air spots (behind a
door), direct sunlight or concealed chimney or stove pipes.
• For a new installation, choose a location about 1.5 m (5 ft.) above the floor.
• Install the thermostat on an inside wall facing the heater.
• Keep the thermostat's top and bottom air vents (openings) clean and unobstructed at all times.
Two mounting plates are provided for mounting the thermostat on the wall or on a junction box.
Use Method A for a slimmer thermostat look. Choose Method B if you prefer not to make an
opening in the wall. Method C must be used for installation on a junction box.

Mount thermostat and outdoor sensor 7.
Recessed mounting on a wall (Method A)
Mark the four corners and
join them to create a
rectangular outline. Cut along the outline to
create an opening in the
wall. Secure the mounting plate to
the wall using provided wall
anchors and screws.
Mounting on a wall
(Method B) Mounting on a junction box
(Method C) Installing faceplate
Secure the mounting
plate to the wall using
provided wall anchors
and screws.
Secure the mounting plate to a
junction box using provided
mechanical screws.
Complete the thermostat
installation by pressing
the faceplate against the
mounting plate.
Use mounting plate with no opening.
69-2472EF-01 (Aube TA7210 System Installation Guide).book Page 19 Wednesday, June 29, 2011 1:15 PM