Aube Technologies TA7210 - Manuel (Page 10)

Installation Guide
10
Link outdoor sensor to wireless network (optional)
1) Make sure the Connect light on the EIM is
flashing (see page 7).
2) Press the Connect button on the back of the
sensor.
3) After 15 seconds, check if the thermostat is displaying a value for the outdoor
temperature reading.
Link remote control to wireless network (optional)
1) Make sure the Connect light on the EIM is flashing (see page 7).
2) Press CONNECT at the remote
control.
3) When the remote control displays
Connected (after a short delay),
press DONE.
4) Press NO at the next screen to save
and exit. (Or press YES and repeat
steps 1-4 to link to another network).
If you have more than one wireless thermostat,
make sure to activate the wireless setup from
an EIM linked to the thermostat. For example,
to display the outdoor temperature on
thermostat Y, you must activate the wireless
setup from either EIM B or C, not A.
If you have more than one wireless thermostat, repeat steps 1 and 3 for each thermostat.
If you have more than one wireless thermostat, make sure to activate the wireless setup
from an EIM linked to the thermostat. For example, to link the remote control to thermostat
Y, you must activate the wireless setup from either EIM B or C, not A.
Press and
release
Remote
control
Thermostat X Thermostat Y
EIM A
EIM B EIM C
Outdoor
sensor
Bathroom
wireless network
Bedroom
wireless network
CONNECT
WIRELESS SETUP
NO YES
CONNECT MORE?
Press to link to
another network Press to
save and exit
69-2472EF-01 (Aube TA7210 System Installation Guide).book Page 10 Wednesday, June 29, 2011 1:15 PM