Panasonic PT DW10000U - Manuel (Page 28)

28 – ENGLISH
Procedure of installation
Disconnect the power before installing the input module.
■
Slot Cover
MAIN POWER AC IN OFF ON
IN OUT RS-232C IN RS-422 IN RS-422 OUT SERIAL LAN REMOTE 1 REMOTE 2 IN
OUT
IN
SYNC/HD VD
B/PB G/Y R/PR
S-VIDEO IN VIDEO RGB 2 IN DVI-D IN RGB 1 IN
AUX
DVI-D
RGB2
RGB1
S-VIDEO
VIDEO
AUTO
SETUP
MENU LENS
SHUTTER
LIGHT
POWER ON STANDBY
ON
OFF
ENTER
Slot Cover
MAIN POWER AC IN OFF ON
IN OUT RS-232C IN RS-422 IN RS-422 OUT SERIAL LAN REMOTE 1 REMOTE 2 IN
OUT
IN
SYNC/HD VD
B/PB G/Y R/PR
S-VIDEO IN VIDEO RGB 2 IN DVI-D IN RGB 1 IN
AUX
DVI-D
RGB2
RGB1
S-VIDEO
VIDEO
AUTO
SETUP
MENU LENS
SHUTTER
LIGHT
POWER ON STANDBY
ON
OFF
ENTER
1. Remove the slot cover.
Remove 2 screws.
2. Insert the input module.
Slot
Input module
3. Fix the input module.
4. Register the input signal.
This projector needs to register the type of
input signal after the installation of the input
module.
For details on the registration of the input
signals, refer to pages 40-42.
•
•
Tighten the two screws.
1. Remove the slot cover.
Remove 2 screws.
2. Insert the input module.
Slot
Input module
3. Fix the input module.
4. Register the input signal.
This projector needs to register the type of
input signal after the installation of the input
module.
For details on the registration of the input
signals, refer to pages 40-42.
•
•
Tighten the two screws.
Installation of input module (optional) (continued)