Pioneer DEH-P770MP - Manuel (Page 54)

Adjusting initial settings
1
Initial settings lets you perform initial setup of
different settings for this unit.
1 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press Multi-Control and hold until the
clock appears in the display.
3 Turn Multi-Control to select one of the
initial settings.
Turn Multi-Control clockwise to switch be-
tween the functions in the following order:
Clock (clock)Warning tone (warning tone)
AUX (auxiliary input)Dimmer (dimmer)
Brightness (brightness)SW control (rear
output and subwoofer controller)Mute (tele-
phone muting/attenuation)Demonstration
(feature demo)Reverse mode (reverse
mode)Ever-scroll (ever scroll)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
Setting the clock
Use these instructions to set the clock.
1 Use Multi-Control to select Clock.
Clock appears in the display.
2 Push Multi-Control left or right to select
the segment of the clock display you wish
to set.
Pushing Multi-Control left or right will select
one segment of the clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3 Push Multi-Control up or down to set
the clock.
Pushing Multi-Control up will increase the
selected hour or minute. Pushing
Multi-Control down will decrease the se-
lected hour or minute.
Notes
! You can match the clock to a time signal by
pressing Multi-Control.
 If the minute is 0029, the minutes are
rounded down. (e.g., 10:18 becomes
10:00.)
 If the minute is 3059, the minutes are
rounded up. (e.g., 10:36 becomes 11:00.)
! Even when the sources are off, the clock dis-
play appears on the display.
Switching the warning tone
If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone will sound. You
can turn off the warning tone.
1 Use Multi-Control to select
Warning tone.
Warning tone appears in the display.
Initial Settings
En
54
Section
12