Pioneer DEH-P770MP - Manuel (Page 51)

3 Push Multi-Control up or down to ad-
just the level.
Each pushing Multi-Control up or down in-
creases or decreases the selected bass or tre-
ble level. +6  6 is displayed as the level is
increased or decreased.
4 Turn Multi-Control clockwise to select
Bass (bass and treble frequency adjust-
ment).
Bass appears in the display.
# If the treble frequency has been previously ad-
justed, Treble will be displayed.
5 Push Multi-Control left or right to select
the desired frequency.
Each pushing Multi-Control left or right se-
lects frequencies in the following order:
Bass: 4063100160 (Hz)
Treble: 2.5k4k6.3k10k (Hz)
Adjusting loudness
Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Use Multi-Control to select LOUD.
LOUD appears in the display.
2 Press Multi-Control to turn loudness
on.
Loudness level (e.g., Mid) appears in the dis-
play.
3 Push Multi-Control left or right to select
a desired level.
Each pushing Multi-Control left or right se-
lects level in the following order:
Low (low)Mid (mid)High (high)
4 To turn loudness off, press
Multi-Control again.
OFF appears in the display.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
1 Use Multi-Control to select Sub-W1.
Sub-W1 appears in the display.
# You can also select the subwoofer setting
menu by pressing SW on the unit.
# When the subwoofer controller setting is
Preout :FULL, you cannot select Sub-W1.
2 Press Multi-Control to turn subwoofer
output on.
Normal appears in the display. Subwoofer out-
put is now on.
# To turn subwoofer output off, press
Multi-Control again.
3 Push Multi-Control left or right to select
the phase of subwoofer output.
Push Multi-Control left to select reverse
phase and Rev. appears in the display. Push
Multi-Control right to select normal phase
and Normal appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Use Multi-Control to select Sub-W2.
Sub-W2 appears in the display.
# You can also select the subwoofer setting
menu by pressing SW on the unit.
# When the subwoofer output is on, you can se-
lect Sub-W2.
2 Push Multi-Control left or right to select
cut-off frequency.
Each pushing Multi-Control left or right se-
lects cut-off frequencies in the following order:
50Hz80Hz125Hz
Audio Adjustments
En
51
English
Section
11