Pioneer SX-315 - Manuel (Page 26)

Additional information 07
26
En
Note
• If the unit does not operate normally due to external
effects such as static electricity, disconnect the
power plug from the outlet and insert again to return
to normal operating conditions.
Cleaning the unit
• Use a polishing cloth or dry cloth to wipe off dust and
dirt.
• When the surface is dirty, wipe with a soft cloth
dipped in some neutral cleanser diluted five or six
times with water, and wrung out well, and then wipe
again with a dry cloth. Do not use furniture wax or
cleansers.
• Never use thinners, benzine, insecticide sprays or
other chemicals on or near this unit, since these will
corrode the surface.
Tuner step setting
You can set the tuning step for the built-in tuner for
optimal tuning in your area. If you find that you can’t tune
into stations very effectively, try changing this setting.
The two settings are AM 9 kHz / FM 50 kHz and AM 10 kHz
/ FM 100 kHz.
1 Switch the receiver into standby.
2 Press and hold FM/AM, then press STANDBY/
ON.
The new tuner step setting is shown in the display.
Input attenuator setting
• Default setting: ATT:OFF
If you experience distortion when you select the TAPE/
VCR input it may be that the input level is too high.
Switching on the input attenuator lowers the input level,
restoring the proper sound.
1 Press SYSTEM SETUP repeatedly until the input
attenuator setting is shown in the display.
The display shows ATT:ON or ATT:OFF for Input
attenuator on and off respectively.
2 Use the / (cursor left/right) buttons to
change the setting.
• You can also use the < and > buttons on the front
panel.
3 Press ENTER to exit System Setup.
Resetting the receiver
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
1 Switch the receiver into standby.
2 Press TONE and SYSTEM SETUP at the same time.
3 When you see RESET? appear in the display,
press the > button.
OK?
shows in the display.
4 Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
Note
• Steps 3 and 4 must be completed within five
seconds, otherwise the receiver will exit the reset
process.
SX-315.book 26 ページ ２００４年１１月８日 月曜日 午前１１時２分