07 additional information, Troubleshooting, Additional information – Pioneer SX-315 Manuel d'utilisation

Page 25: Additional information 07, Chapter 07

Advertising
background image

Additional information

07

25

En

English

Chapter 07:

Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with
this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other
components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks
listed below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.

Problem

Remedy

The power does not turn on.

• Connect the power plug to the wall outlet.
• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the rear panel. This could
cause the receiver to shut off automatically.
• If the power shuts off automatically, take the unit to your

nearest Pioneer authorized

service center or your dealer for servicing.

No sound is output when a
function is selected.

• Make sure the component is connected correctly (refer to

Connecting up

on page 7).

• Press

MUTE

on the remote control to turn muting off.

• Adjust the

MASTER VOLUME

.

Considerable noise in radio
broadcasts.

• Tune in the correct frequency.
• Connect the antenna (refer to page 9).
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and secure to a wall, etc.
• Connect an outdoor FM antenna (refer to page 9).
• Adjust the direction and position for best reception.
• Connect an additional internal or external AM antenna (refer to page 9).
• Turn off the equipment causing the noise or move it away from the receiver.
• Move antennas farther away from equipment causing the noise.

Broadcast stations cannot be
selected automatically.

• Connect an outdoor antenna (refer to page 9).

No sound from surround or
center speakers.

• Connect the speakers properly (refer to page 10).

No sound from subwoofer.

• Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• The Dolby Digital or DTS source you are listening to does not have an LFE channel.

Noise during playback of a
cassette deck.

• Move the cassette deck further from your receiver, until the noise disappears.

When a search is performed
by a DTS compatible CD
player during playback, noise
is output.

• This is not a malfunction, but be sure to turn the volume down to prevent the output of
loud noise from your speakers.

Can’t operate the remote
control.

• Replace the batteries (refer to page 6).
• Operate within 21 ft. / 7 m, 30° of the remote sensor on the front panel (refer to page 6).
• Remove obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.

The display is dark or off.

• Press

DIMMER

on the remote control repeatedly to return to the default.

SX-315.book 25 ページ 2004年11月8日 月曜日 午前11時2分

Advertising