10 additional information, Troubleshooting, Additional information – Pioneer VSX-516 Manuel d'utilisation

Page 35: Additional information 10, Chapter 10

Advertising
background image

Additional information

10

35

En

English

Français

Deutsch

Nederlands

Italiano

Español

Chapter 10:

Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is
something wrong with this component, check the points below. Sometimes the trouble may lie in
another component. Investigate the other components and electrical appliances being used. If the
trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer
authorized service center or your dealer to carry out repair work.

• If the unit does not operate normally due to external effects such as static electricity

disconnect the power plug from the outlet and insert again to return to normal operating
conditions.

Problem

Remedy

The power does not turn on.

• Disconnect the power plug from the outlet, and insert again.
• Make sure there are no loose strands of speaker wire touching the
rear panel. This could cause the receiver to shut off automatically.
• If the power shuts off automatically, take the unit to your nearest
Pioneer authorized service center or your dealer for servicing.

No sound is output when a
function is selected.

• Make sure the component is connected correctly (refer to

Connecting up

on page 8).

• Press

MUTE

on the remote control to turn muting off.

No image is output when a
function is selected.

• Make sure the component is connected correctly (refer to

Connecting up

on page 8).

• Select the correct component (use the input select buttons).

Considerable noise in radio
broadcasts.

• Connect the antenna (page 13) and adjust the position for best
reception.
• Route any loose cables away from the antenna terminals and wires.
• Fully extend the FM wire antenna, position for best reception, and
secure to a wall (or connect an outdoor FM antenna).
• Connect an additional internal or external AM antenna (page 13).
• Turn off equipment causing interference or move it away from the
receiver (or move antennas farther away from equipment causing
noise).

Broadcast stations cannot be
selected automatically.

• Connect an outdoor antenna (refer to page 13).

No sound from surround or
center speakers.

• Connect the speakers properly (refer to page 14).
• Refer to

Speaker setting

on page 28 to check the speaker settings.

• Refer to

Channel level

on page 28 to check the speaker levels.

VSX_516.fm 35 ページ 2005年11月29日 火曜日 午後12時27分

Advertising