Pioneer VSX-516 - Manuel (Page 33)

Other connections 09
33
En
English
Français
Deutsch
Nederlands
Italiano
Español
Chapter 9:
Other connections
Caution
• Before making or changing the connections ,
switch off the power and disconnect the
power cord from the power outlet.
• Be careful not to allow any contact
between speaker wires from different
terminals.
• You can use speakers with a nominal
impedance between 6–16 Ω (please see
Switching the speaker impedance on
page 37 if you plan to use speakers with an
impedance of less than 8
Ω ).
Second Zone speaker B setup
After selecting SB 2ND Z in Surround back
speaker setting on page 27, you can use the
speakers connected to the (surround back) B
speaker terminals on the rear panel to listen to
stereo playback in another room. See
Switching the speaker system below for the
listening options with this setup.
1 Connect a pair of speakers to the
surround back speaker terminals on the rear
panel.
Connect them the same way you connected
your speakers in
Connecting the speakers on
page 14. Make sure to review Hints on speaker
placement on page 15 when placing the
speakers in another room.
2 Select SB 2ND Z from the ‘ SB. SYSTEM’
menu.
See Surround back speaker setting on page 27
to do this.
Switching the speaker system
If you selected SB 2ND Z in Surround back
speaker setting on page 27, three speaker
system settings are possible using the
SPEAKERS button. If you selected SB NORM.
or SB BIAMP , the speaker system is fixed as
SP A or SP AB (respectively). The options
below are for the SB 2ND Z setting only.
1
• Use the SPEAKERS button on the front
panel to select a speaker system setting.
Press repeatedly to choose a speaker system
option:
• SP A – Sound is output from the speakers
connected to the A speaker terminals
(multichannel playback is possible).
• SP B – Sound is output from the two
speakers connected to speaker system B
(only stereo playback is possible).
• SP AB – Sound is output from speaker
system A (up to 5 channels, depending on
the source), the two speakers in speaker
system B, and the subwoofer.
Multichannel sources (heard through
speaker system A) are downmixed for
stereo output from speaker system B.
Note
1 • The subwoofer output depends on the settings you made in Speaker setting on page 28. However, if SP B is selected above,
no sound is heard from the subwoofer (the LFE channel is not downmixed).
• Depending on the Surround back speaker setting on page 27 output from the surround back pre-out terminals may change.
• All speaker systems (except SB 2ND Z connections) are switched off when headphones are connected.
MIDNIGHT/
LOUDNESS
QUICK
SETUP
SETUP RETURN MUTE TONE
ANALOG
ATT SPEAKERS
TUNER
EDIT
DIMMER
MULTI JOG
VSX_516.fm 33 ページ ２００５年１１月２９日 火曜日 午後１２時２７分