Sharp FP-N60CX - Manuel (Page 17)

ENGLISH
Plasmacluster
AUTO MANUAL
Fan Control
POLLEN
OFF
TIMER
DISPLAY
ON/OFF
POWER ON/OFF FILTER RESET
CLEAN
ION CONTROL
OFF AUTO
E-15
REMOTE CONTROL OPERATION
Operations available with
the Remote Control
• AUTO
• MANUAL
• POLLEN
• OFF TIMER
• DISPLAY ON/OFF
Plasmacluster ion mode
selections
• AUTO
• CLEAN
• ION CONTROL
• OFF
• When you press the POWER ON/OFF Button, a short beep will
sound and operation will start. As the initial operation mode, it
automatically goes to the AUTO (Fan level) and AUTO
Plasmacluster ion Mode.
• To stop operation, press the POWER ON/OFF Button again.
A long beep will sound and operation will stop.
POWER ON/OFF Button
Used to start AUTO operation
of the unit. A short beep will
signal that the unit is on and
a long beep means that the
unit is off.
Auto (Fan Level) Button
The fan level switches auto-
matically depending on the
amount of impurities in the air.
Manual (Fan Level) Button
The fan level can be switched
between Silent, Medium, High
and Max.
Display ON/OFF Button
Switches the Plasmacluster
Indicator Light and CLEAN-
SIGN Light either ON or OFF.
• The Plasmacluster Indicator
Light is turned on for about
3 seconds by pressing the
Plasmacluster Ion Select
Button (except for the OFF
Button) during “Display
OFF” mode.
Transmitter
Filter Reset Button
When you have cleaned the
Washable Active Carbon Filter
and re-inserted into the main
unit, press the Filter Reset But-
ton with an instrument with a
point such as a pen.
Pollen Mode Operation Button
The unit operates effectively
when you suspect there is pol-
len in the air. See Page E-14
Off Timer Button
Used to set the Off Timer.
The set time switches every time
the button is pressed as shown
below.
1 hour 4 hours
Cancel 8 hours
• The indicator light shows the re-
maining time.
• The unit will cease operating
when the timer is up.
Plasmacluster Ion mode Selections
Auto
When pressed, the unit will switch between
Clean Mode and the Ion Control Mode auto-
matically depending on the amount of impuri-
ties in the air as detected by the dust and odor
sensors. Clean Mode will operate for about 1
minute when the Auto function is selected.
Ion Control
When pressed, the unit will constantly oper-
ate in Ion Control Mode.
Ion balance is maintained in the room envi-
ronment by increasing the ratio of negative
ions. (The Plasmacluster Indicator Light is
green)
Clean
When pressed, the unit will con-
stantly operate in the Clean Mode,
in which the same numbers of posi-
tive and negative ions are dis-
charged. (The Plasmacluster Indi-
cator Light is blue.)
Off
The generation of ions will cease
and the Plasmacluster Indicator
Light will go out.
If the room is damp or has a mold problem, operate the unit in Clean Mode.