Onnecting, Isconnecting, Igabit – Juniper Networks 5000 SERIES Manuel d'utilisation

Page 46: Thernet, Ables

Advertising
background image

Chapter 4 Servicing the Device

38

User’s Guide

5.

Close the injector/ejector level to fully seat the fan module.

6.

Secure the fan module in place by tightening the thumbscrew in the lock
position.

To replace the fan module on a NetScreen-5400:

1.

Loosen the top and bottom thumbscrews, turning them counterclockwise.

2.

Grip the screws then gently slide the fan module out.

3.

Insert the new fan module in the fan bay, then push it straight in.

4.

Secure the fan module in place by tightening the thumbscrews clockwise.

C

ONNECTING

AND

D

ISCONNECTING

G

IGABIT

E

THERNET

C

ABLES

To connect a Gigabit Ethernet cable to a mini-GBIC connector transceiver port:

1.

Hold the cable clip firmly but gently between your thumb and forefinger, with
your thumb on top of the clip and your finger under the clip. (Do not depress the
clip ejector on top of the clip.)

2.

Slide the clip into the transceiver port until it clicks into place. Because the fit is
close, you may have to apply some force to seat the clip. Apply force evenly and
gently, to avoid clip breakage.

To remove the cable from the transceiver port:

1.

Make sure the black transceiver ejector under the port is not pressed in;
otherwise, when you attempt to remove the cable, the transceiver might come
out with the cable still attached.

2.

Hold the cable clip firmly but gently between your thumb and forefinger, with
your thumb on top of the clip and your finger under the clip.

3.

Use your thumb to gently press the clip ejector on top of the clip, down then
forward. This action loosens the clip from the transceiver port.

4.

Gently but firmly, pull the clip from the transceiver port.

Warning:

Do not remove the fan module while the fans are still spinning.

Advertising