Juniper Networks 5000 SERIES - Manuel (Page 42)

Chapter 3 Configuring the Device
34 User’s Guide
3. Press the y key.
The following message appears:
!! Reconfirm Lost Password Reset !! If you continue, the entire configuration of
the device will be erased. In addition, a permanent counter will be incremented to
signify that this device has been reset. This is your last chance to cancel this
command. If you proceed, the device will return to factory default configuration,
which is: System IP: 192.168.1.1; username: netscreen; password: netscreen.
Would you like to continue? y/[n]
4. Press the y key to reset the device.
You can now login in using netscreen as the default admin name and password.
Note: After you successfully reset and reconfigure the NetScreen-5000 Series, you
should back up the new configuration setting. As a precaution against lost
passwords, you should back up a new configuration that contains the NetScreen
default password. This will ensure a quick recovery of a lost configuration. You
should change the password on the system as soon as possible. For detailed
information about configuration backups, see the System Parameters section in
the NetScreen Concepts & Examples ScreenOS Reference Guide.