Juniper Networks 5000 SERIES - Manuel (Page 32)

Chapter 3 Configuring the Device
24 User’s Guide
NetScreen-5400 Interfaces
A NetScreen-5400 contains one management module (in slot 1) and up to three SPMs. You
can use a 5000-M or a 5000-M2 management module in slot 1. In the illustrations below,
the device contains three 5000-8G SPMs.
Configurable Interfaces
The configurable interfaces available on a NetScreen-5000 Series device are as follows:
Interface Type Description
Ethernet interfaces ethernetn1/n2 specifies a physical ethernet interface, denoted by an interface
module in a slot (n1) and a physical port (n2) on the module.
ethernetn1/n2.n3 specifies a logical interface, denoted by an interface
module in a slot (n1), a physical port (n2) on the module, and a logical
interface number ( .n3). You create logical interfaces using the set interface
command.
Layer-2 interfaces vlan1 specifies the interface used for management and VPN while the
NetScreen device is in Transparent mode.
Tunnel interfaces tunnel.n specifies a tunnel interface. Use this interface for VPN traffic.
Function interfaces mgt specifies a dedicated management interface bound to the MGT zone.
ha1 and ha2 specify the names of the dedicated HA ports.
MGT Port
ethernet4/1
Modem Port Console Port
ethernet4/2
ethernet4/3
ethernet4/4
ethernet4/5
ethernet4/6
ethernet4/7
ethernet4/8
HA Ports
SPM, slot 2
SPM, slot 3
SPM, slot 4