Using cli commands to reset the device, Cli c, Sing – Juniper Networks 5000 SERIES Manuel d'utilisation

Page 41: Ommands, Eset, Evice

Advertising
background image

Using CLI Commands to Reset the Device

NetScreen-5000 Series

33

Notice that the listing contains aggregate1, an aggregate interface comprised of
ethernet2/1 and ethernet2/2. This aggregate interface runs with a throughput
rate of 2 Gbps. You can now bind the aggregate interface to a zone.

U

SING

CLI C

OMMANDS

TO

R

ESET

THE

D

EVICE

If you lose the admin password, you can use the following procedure to reset the
NetScreen-5000 Series device to its default settings. This destroys any existing
configurations, but restores access to the device.

To perform this operation, you need to make a console connection, as described in

“Establishing a Terminal Emulator Connection” on page 25

.

1.

At the login prompt, type the serial number of the NetScreen-5000 Series device.

2.

At the password prompt, type the serial number again.

The following message appears:

!!! Lost Password Reset !!! You have initiated a command to reset the device to
factory defaults, clearing all current configuration, keys and settings. Would you
like to continue? y/[n]

Note:

As with most other interfaces, you must assign the aggregate interface an

IP address so that other nodes on the network can reach it.

Warning:

Resetting the NetScreen-5000 Series will delete all existing configuration

settings, and the firewall and VPN services will be rendered inoperative.

Note:

By default the device recovery feature is enabled. You can disable it by entering the

following CLI command: unset admin device-reset.

Advertising