eMachines H3120 - Manuel (Page 63)

CHAPTER 6: Networking Your Computer www.emachines.com
56
In addition to a router, you need a straight-through cable for each computer
you want to connect to the network.
To set up a network using a router:
1 Plug one end of the power adapter into the AC connector on the router
and the other end into a grounded, 110V electrical outlet.
2 Turn on your computers.
3 Plug one end of a straight-through network cable into any numbered port
on the router (except the WAN port). The WAN port is used to connect the
router to the DSL or cable modem, and is identified by a label or a switch.
Plug the other end of the cable into the network connector on the
computer. As each computer is connected to the router, the
corresponding green indicator should light on the front of the router,
indicating a good connection.
4 Repeat Step 3 for each computer on the network.
5 For an Internet connection, plug a straight-through cable into the WAN
port on the router and the other end into the Ethernet jack on the DSL or
cable modem.
Router
WAN port
Cable/DSL
modem