eMachines H3120 - Manuel (Page 161)

CHAPTER 13: Adding and Replacing Components www.emachines.com
154
4 Remove the screw that secures the hard drive bay to the case.
5 Slide the hard drive bay away from the system board and toward the open
side of the case, then remove the hard drive bay from the case.
6 If you are adding a new drive, go to Step 9 . If you are replacing an existing
drive, go to the next step.
7 Remove the four screws that secure the hard drive to the drive bay. (Only
the two screws on one side of the bay are shown below.)
8 Slide the old drive out of the bay.
9 Slide the new drive into the drive bay.
10 Use the four screws you removed previously to secure the hard drive to
the hard drive bay.
Screw
Screws