eMachines H3120 - Manuel (Page 160)

Adding or replacing a hard drive www.emachines.com
153
5 Slide the card reader out of the case.
6 Slide the new card reader into the bay from the front of the case.
7 Connect the new card reader’s USB cable to the system board.
8 Use the screw you removed previously to secure the card reader to the bay.
9 Replace the front bezel by following the instructions in “Replacing the
front bezel” on page 147 .
10 Replace the side panel by following the instructions in “Replacing the side
panel” on page 147 .
Adding or replacing a hard drive
Tips & Tricks
You need a Phillips screwdriver to add or
replace a hard drive.
To add or replace a hard drive:
1 Remove the side panel by following the instructions in “Removing the side
panel” on page 144 .
2 If you are adding a new drive, go to Step 4 . If you are replacing an existing
drive, go to the next step.
3 Disconnect the power and data cables from the back of the hard drive.