eMachines H3120 - Manuel (Page 157)

CHAPTER 13: Adding and Replacing Components www.emachines.com
150
Important
Your computer’s battery location may
vary from the illustration below.
9 Make sure that the positive (+) side of the new battery is facing up, then
press the battery into the socket until it snaps into place.
10 Replace the side panel by following the instructions in “Replacing the side
panel” on page 147 .
11 Turn on your computer.
12 Open the BIOS Setup utility and restore any settings that you wrote down
in
Step 3 .
13 Save your settings and exit the BIOS Setup utility.
Adding or replacing a CD or DVD drive
Tips & Tricks
You need a Phillips screwdriver to add or
replace a CD or DVD drive.
To add replace a CD or DVD drive:
Important
The color and shape of your
replacement component's front
cover may vary from your original
component.
1 Remove the side panel by following the instructions in “Removing the side
panel” on page 144 .
2 Remove the front bezel by following the instructions in “Removing the
front bezel” on page 146 .
3 If you are replacing an existing drive, remove the two screws that secure
the drive to the drive bay. If you are adding a new drive, go to
Step 6 .
Screws