Elmo Visual Presenter HV-110U - Manuel (Page 18)

18
SETTING UP AND
ST
ORING
English
Connecting
(1) Connecting to the unit equipped with analog RGB input terminal
Connect the supplied analog RGB cable to the [RGB OUT] terminal on the rear panel.
• The display position may be displaced from the center of the screen. In such case, adjust
the horizontal and vertical positions manually from the connected device.
• Vertical strips may appear on the projector or PC monitor screen. This can be mitigated
by manually adjusting the dot clock from the connected device.
(2) Connecting to the unit equipped with analog RGB output terminal
Connect the supplied or separately-sold analog RGB cable to the [RGB IN] terminal on the
rear panel.
Note
• When using a laptop PC with an external output mode switching, set the laptop PC
side to the external output mode after pushing the manual operation button [PC] of this
equipment.
• When the power switch is turned to [OFF], the image that has been input into the [RGB
IN] terminal will be output from the [RGB OUT] terminal, regardless of the position of
the Image Input Selection Switch.
(2) RGB IN terminal
•To PC (1) RGB OUT terminal
• To projector
• To PC monitor
(3) USB terminal
• To PC
(4) DC IN 12V terminal
• To DC plug