Epson WORKFORCE WP-4530 - Manuel (Page 13)

Receiving Faxes 13
■ If you are scanning with the ADF (see page 5), your document is automatically
scanned and faxed.
■ If you placed your document on the scanner glass, you can scan additional pages
after the first one is sent.
■ If the fax number is busy, you see a redialing message and the product redials
after one minute. To redial immediately, press
Redial/Pause .
Note: If you turn off the product, the following data stored in the product’s temporary
memory will be lost: received faxes that haven’t yet been printed, faxes scheduled to
be sent later, and faxes being retransmitted automatically.
Receiving Faxes
Before receiving faxes, make sure you load plain paper and select the correct settings for the
paper you’ve loaded.
1. Press F Setup .
2. Select Fax Settings .
3. Select Receive Settings .
4. Select Paper Source to Print.
5. Select the paper source you want to change, then change the setting.
Note: If the incoming fax is larger than the paper you loaded, it is reduced to fit or
printed on multiple pages, depending on the Auto Reduction setting you select.
6. To receive faxes automatically, make sure you see a green light next to ( Auto
Answer) on the control panel. If the light is off, press .
Note: To change the number of rings before the product answers, see page 12.
If you run out of paper during printing, you see an error message. Load more paper and
press one of the x
Start buttons to continue.